How to fit your greengauges time clock
CAI Clock
IMPORTANT INFORMATION
- Only to be fitted to negative earth vehicles.
- Disconnect your vehicle’s battery prior to installation.
Wiring
See diagram
- Connect terminal A to the positive electrical supply via a 3 amp fuse
- Connect terminal B to earth/ground via the chassis/body, i.e. any place that takes this connection back to the negative side of the battery
Illumination
- Assemble bulb into holder
- Install bulb and holder into the lamp aperture at the rear of the gauge.
- Connect one wire from the bulb and holder assembly to the power feed for the fascia lighting, connect the other wire to earth/ground via the vehicle chassis/body.
Installation
These gauges require a 2 1/16 inch (52mm) hole in the fascia panel. Insert the gauge into the hole and secure with the fixing clamp, washers and knurled nuts supplied.
Setting the time
- The vehicle’s power supply needs to be connected for the time setting function to work.
- To advance one minute depress the reset plunger once
- To advance by more than one minute press and hold the reset plunger until the desired time is reached.
|
